‍

ROUNDCODE Figure Power Unit

‍

_{Product description & User Manual}

_{It is a device for figures including toys that contain LED devices.
Instead of the mercury cell, all LEDs of the product can be turned on/off by inserting the corresponding power unit.
This product is designed for people who don't like mercury cells and is designed for self-installation.
Designed to fit all kinds of mercury battery size specifications in toy figures.
Designed to conform to AAA battery size specifications on the base stand.
insert the mercury cell in accordance with the specifications of the mercury cell.
Springs are mounted at both ends of the power unit, which causes current to flow to the ground of both ends of the mercury cell.}

_{Other options}

_{Control switch
Remote Control
Collectors can purchase according to the number of LED devices they want}

_{Product Specifications}

_{The supply device of the corresponding power unit is a device that can be used for a basic 6-point or 12-point mercury battery.
The power unit's supply can be expanded to 24 points.Customizable to 3~5V, or Up to 24V 3A}

‍

Add 2024.05.11 Notes

If AG0 does not meet the specifications, you should use AG1.

We'll explain why below.

Q. Q: My power supply is not the right size.

A. Actually, the AG0 is designed to be interchangeable with the AG1, depending on the state of the product.

This is because the specifications of mercury batteries are often misrepresented in Hot Toys' product guide manuals.

Most Hot Toy buyers don't realize this error because they insert mercury batteries into their Iron Man products without looking at the manual.

However, when you purchase a power unit, you are reading the hot toy manual and ordering the correct battery size.

Note that this is the cause of the error.

If possible, don't rely on the product manual, and make sure you have a rough estimate of the size of the mercury battery compartment on the actual product.

If your AG0 doesn't fit the specifications, press the spring as hard as you can from both sides and then insert it with special tweezers.

When inserting, it is important to press down on the power unit with the thumb of your left hand to make sure it is fully seated.

If the compartment is too wide for AG0 to fit, use AG1.

Q. Are the springs solderable?

A. No, the springs are not solderable - they are not solderable.

Q. If I use a power unit, will it damage the LEDs in the product?

A. With the power unit, there is no need to worry about overloading the LEDs.

This product has a resistor design in the body of the USB line. It is precisely adjusted from a minimum of 3.5V to a maximum of 4.5V.

We can also adjust this power consumption up to 24V upon customer request.

However, for hot toys, the current power is suitable.

‍

Thank you.

‍

‍

‍

‍

‍_{Remote Control Remote Control Detailed Option Description}

_{the light gradually brightens
the light will gradually dim
lightly press 6 levels to adjust
tap 6 levels to adjust
Breathing light
Flashing light
Dedicated at night/dim light
Unlock timer shutdown
Timed two -hours
Multi-time specification timing}

‍

‍

                                   User Manual

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍

‍
‍

‍

‍

‍

‍

‍

^{※ It only covers the product. I don't use the battery cover. Keep it safe and safe to cover the battery.}

^{When closing the cover of the product, close the cover so that the line does not interfere.}

‍

‍

‍

‍

‍

‍

‍

                           _{Installation Guide to Power Unit Products Video}

‍

‍